What medicine should I use for skin burns caused by electric welding?

If welders do not pay attention to the operating specifications when using welding, it may cause welding to injure the skin. This is a typical symptom of burns. When this happens, some first aid methods should be taken immediately for treatment. You can first use iodine tincture for disinfection, and then use some burn ointment to achieve the anti-inflammatory effect. In your daily diet, you should also pay attention to avoiding dietary stimulation and pay attention to the cleanliness of the burned area.

Treatment of skin burns caused by electric welding:

1. The burned skin will peel off after three or four days. Do not peel it off with your hands at this time. Let it fall off on its own. During the peeling process, mix a little milk with water and apply it to the skin with cotton. This will help the skin to adjust itself, relieve pain and accelerate skin recovery.

2. If your face is injured by electric welding, you should apply fresh milk to the radiated area and allow the milk to be slowly absorbed by the injured area. Repeat several times. Your face will not peel or hurt the next day. Remember, never wash your face with cold water, use hot water, otherwise your face will peel.

3. Electric welding burns are arc burns and fall into the category of burns. If your face is itchy and painful, first try to avoid getting burned again. Second, you can use ointments for treating burns. Third, try to protect your skin from damage to avoid infection. If it is damaged, antibiotics should be taken routinely.

4. Skin burns caused by electric welding is a very serious symptom. Electric welding is very lethal and can cause physical discomfort. Generally, skin burns caused by electric welding must be treated, and will only get better with good care.

5. In case of skin burns caused by electric welding, it is best to first gently apply aloe vera to the affected area, then go to the hospital's dermatology department for examination, and then receive professional treatment. Skin burns caused by electric welding must not be exposed to water. It is best to disinfect it with alcohol first, and then use ointment for treatment to avoid infection. The wound must be kept clean and not exposed to water.

Dangers of skin burns from electric welding

1: In mild cases, the skin burned by radiation will turn red. The pain of mild burns will gradually disappear after using relevant treatment drugs or not using them. There may be slight peeling after healing.

2: In severe cases, the skin burned by radiation will turn dark red. If the skin fails to improve and recover after using relevant treatment drugs or not, burn edema will occur and the burned area will peel off a lot. After healing, permanent burn scars will be left.