What to do if your skin is burned by electric welding? How to care for burns

I don’t know how many people have seen electric welding. The scene of operating in the midst of electric sparks once made people feel thrilling and exciting. However, electric welding is actually a very dangerous thing, because if you are not careful, you may get burned by it. What should you do if you are burned by electric welding?

1: In mild cases, the skin burned by radiation will turn red. The pain of mild burns will gradually disappear after using relevant treatment drugs or not using them. There may be slight peeling after healing.

2: In severe cases, the skin burned by radiation will turn dark red. If the skin fails to improve and recover after using relevant treatment drugs or not, burn edema will occur and the burned area will peel off a lot. After healing, permanent burn scars will be left.

1: The burned skin will peel off after three or four days. Do not peel it off with your hands at this time. Let it fall off on its own. During the peeling process, mix a little milk with water and apply it to the skin with cotton. This will help the skin to adjust itself, relieve pain and accelerate skin recovery.

2: If your face is injured by electric welding, apply fresh milk to the irradiated area. Allow the milk to slowly be absorbed by the injured area. Repeat several times. Your face will not peel or hurt the next day. Remember, never wash your face with cold water, use hot water, otherwise your face will peel.

3: Electric welding burns are arc burns and fall into the category of burns. If your face is itchy and painful, first try to avoid getting burned again. Second, you can use ointments for treating burns. Third, try to protect your skin from damage to avoid infection. If it is damaged, antibiotics should be taken routinely.

4: Electric welding burns to the skin is a very serious symptom. Electric welding is very lethal and can cause physical discomfort. Generally, electric welding burns to the skin must be treated, and will only get better with good care.

5: In case of skin burns caused by electric welding, it is best to first gently apply aloe vera to the affected area, then go to the hospital's dermatology department for examination, and then receive professional treatment. Skin burns caused by electric welding must not be exposed to water. It is best to disinfect it with alcohol first, and then use ointment for treatment to avoid infection. The wound must be kept clean and not exposed to water.

During the welding process, the safety operating procedures of electric welding are not strictly followed, resulting in burns to the skin of the workers, or the body being burned by the welding arc (a continuous dazzling light, sometimes with the appearance of a glow arc, formed when the circuit is disconnected. That is, the light emitted by the arc is very strong and bluish-purple.) radiation.